Cuisinart Buona Tazza EM-600 SERIES, Инструкция/Рецепты

Страница: 8 / 20

7
2. With a coffee cup or mug on the drip tray,
select COFFEE (approximately 6 ounces).
(The coffee setting and if applicable the
temperature setting LEDs remain on, while all
the other LEDs are off. Once all LEDs are on
again, the machine is ready for the next
cycle.)
CAUTION: Scalding may occur if the brewing
head is opened during brewing cycle.
Reminder: There is no need to rinse in between
cycles as there will be no transfer of flavor. See
Espresso section
NOTE on previous page.
Manual/Adjustable Strength Control
1. Using the lever, open the brew head, insert a
capsule, and close the brew head.
2. For adjustable strength
control, use the MANUAL
button to adjust the length
of time espresso or coffee
is dispensing – the longer
you allow it to flow, the
lighter it will be.
Press to start dispensing. When your
cup is filled to desired level, press again
to stop. Manual function will time-out after 90
seconds.
PROGRAMMING
A CUSTOM SETTING
At ready mode, press and hold MANUAL
for 3 seconds to customize the SHORT
,
LONG and COFFEE output.
1. , , are flashing and is ON. If no
action is taken within 30 seconds, unit
returns to preheat/ready mode.
2. Press , or button.
a. Chosen setting and LEDs remain on.
b. Espresso/coffee is dispensed.
c. When desired amount is dispensed into
cup, press chosen setting again to stop.
That will be the programmed amount and
unit will return to preheat/ready mode.
d. If no action is taken during dispensing
within 90 seconds, unit returns to preheat/
ready mode. Setting will not be changed.
To reset any setting to factory default (at ready
mode), press and hold and chosen setting at
the same time for 3 seconds.
1. or or and LEDs flash 3 times.
2. Default setting is on and unit will return to
preheat/ready mode.
STEAM/FROTHING MILK
1. Remove the milk tank by holding the milk
tank and cover, and pull away from the
machine. Remove the cover by pushing on
cover release button on back of milk tank.
2. Pour milk into the tank, above
minimum fill line (5 ounces),
but not exceeding the
maximum fill line (22 ounces).
3. Replace the cover, align the
milk tank to the connector
on the side of the machine,
and push in to install.
CAPPUCCINO , LATTE
and STEAM will begin
to flash. This indicates that
the milk tank is properly
installed.
4. Place a mug on the drip tray and position the
steam/frothing wand in the mug. Adjust the
length of the stainless steel sleeve on the
wand so it is the proper length for your mug.
5. Once lights are steady lit press the STEAM
button to start steaming/frothing, and use
the steam control dial to control the air/froth.
Press again to stop steaming/frothing.
Steam function will time-out after 30
seconds.
NOTES:
r 5VSOJOHUIFTUFBNDPOUSPMEJBM
to the right creates more
froth.