Cubix Corporation
2800 Lockheed Way
Carson City, NV 89706-0713 ● Page 12
Sales 800.829.0550
http://www.cubix.com
xprm8g3-1625urp-20170801
Replace a Power Supply Module
All power supply modules show a steady green LED when operating normally. A module with a
red LED is either disconnected from power or has a fault. Check that the power cord is firmly
seated. If an LED remains red, replace the module.
Shipping Procedure
Before shipping Xpander, remove any installed graphics or other controller(s) using the
following procedure:
1. Switch off the host computer connected to Xpander.
2. Disconnect power from Xpander.
3. Disconnect Xpander from the HIC(s).
4. Remove the secure screws holding the Xpander in the cabinet.
5. Gently pull the Xpander toward you.
6. Lift Xpander down from the cabinet and set it on a stable surface.
7. Remove the screws holding Xpander top cover, remove it and set it aside.
8. Remove the graphics or other controllers and pack them in the original packaging.
9. Replace the hold-down brackets and tighten the captured screws.
10. Pack the graphics cards or other controllers within the boxes in which you received them.
11. Replace the Xpander Rackmount Elite front top cover, replace the screws and remove the
power cords.
12. Remove the two outer slide mounts by sliding each out until it stops. Press the catch to
release and remove the outer slide mount.
13. Remove the two slide mounts from the Xpander sides.
14. Store all of the screws, nuts and G-nuts in the plastic bag included. Tape the bag to the rails
and wrap the rails together.
15. Remove the HIC(s) from the host computer.
16. Within the original packaging, pack the Xpander, the power cords, the HIC(s) and the boxed
graphics cards. Include a copy of these instructions.
Warning
Before lifting Xpander out of a cabinet, ask for assistance.
Warning
Remove GPUs or other adapters before shipping Xpander.
