7
In connection with the PixHawk flight
•Insert the HackLink data interface end into the teleml or telem2 transmission interface of the flight control
• Then insert the DSM remote control signal into the DSM interface of the flight control
Notes
：
1. If the ground is not connected to the remote control or receiver, do not plug the DSM interface
2. If the flight control is connected to the receiver, do not insert the DSM interface simultaneously.
Connect camera
• HackLink compatible with HDMI output, and the 720P signal camera is required.
• Please turn off the camera's WIFI function before installation to avoid interference.
• Insert the attached MICRO HDMI soft line into AIR side micro HDMI interface
• The other end is inserted into the camera's Micro HDMI interface
Note
：
The current standard HDMI line for double micro HDMI interface. Other interfaces require additional purchases.
Test whether the communication is normal
1.
Connect HackLinkAIR with flight control, then power on. Wait for the start light (blue) flashing and the wireless status light
always bright (green).
2. Open the HackLink ground power supply (long press the power button 5 seconds), the system will boot, probably system
startup success in 30s, the screen will display waiting.
3. Wait, and the AIR end blue light will become bright
4. The ground screen display control data (voltage mode and signal state) mavlink
5. The normal boot on the ground and the successful connection OLED display flow chart
