22
pairing and restoring system
HackLink
At present, the factory has done a good pairing operation, no need to do the pairing operation after receiving..
Only to upgrade the system or do a restore system operation, you need to re pairing/
How to determine whether HackLink has been successfully matched
Status light (
Power lamp red system status lamp blue wireless status lamp green).
Power on the AIR, turn on GR, and wait 1 minutes, after the system is started. The normal state should be as follows
G R
：
Start light flashes (blue) (that has been started; Wireless state light (green) bright, wireless RF card is activated
AIR
：
Start status light (blue)bright (Connected to GR), Wireless state light (green) bright, wireless RF card is activated
pairing process
It is simple and requires only a few steps
1.
Start and power on, waiting for indicators bright
2.
Use a toothpick or pointed tool (such as paper clips and tweezers) to press Pair button for 5 seconds
3.
After a period of time, OLED end will prompt to find a new AIR end
4.
Press X key don't let go, after prompting paired, release the button
5.
About 15 seconds later, the pairing is successful
Restore system operating instructions
Note: make sure the battery is 20 % above before the restore of the system
Ground end restore process:
1.
In shutdown state
2.
Press the X key, then press the power button.
3.
After the start , press X button, till OLED screen prompts to restore system.
