Section 2 System Programming
2.1.1 This system has a default factory setting. If any of the programming needs to be
changed, the user can change the setting by system programming.
2.1.2
2.1.3 The user should input the password to enter the system programming.
2.1.4
2.1.5
2.1.6
2.1.7
2.1.8 In this manual, we have marked when the functions are different for different
model AK,HK,DK,VK.
All programming must be operated on extension 1 (default is 8001) or by computer
when use our CTI software. When extension is at direct outgoing mode, please input
'' * '' to enter internal dial mode first, then go ahead.
Input '' * '' to start program and end with '' #'', allows input '' * '' to restart program
in the event of failure program occurs.
A long BEEP tone indicates correct programming, if instead of three serial BEEP
tone indicates error programming.
If without special remark, here in manual extension number ''ABCD'' indicates
extension current number, not default extension number.
Any extension is capable connect with our key telephone, plug and play when change
single line telephone to key telephone; however, when change key telephone to single
line telephone, you are required to input format
###0
on key telephone first,
otherwise, system may doesn't operates properly.
2.2
Default Values
* Attendant mode: Operator Attendant
* Ringing extension at operator attendant: 8001,8002,8003,8004
* Operator No.1Extension at auto-attendant: 8002
Operator No.2 Extension at auto-attendant: 8003
* External Dial Mode: Dial 0 or Select CO line
* CO line Caller ID mode: Standard FSK, DTMF
* Trunk Group: Not set
* Extension / CO line group: 0
* Extension outgoing class: No restriction
* Restricted/ Licence Prefix Digits: Not set
* Extension / CO lines Monitor Record mode: Not set
* Extension External Call Time Limited: Not set
* Hook-Switch Flash time:760 ms
13
2.1 General Programming Instructions