CTI 2500-RIO-B, Инструкция по установке и эксплуатации

Страница: 5 / 27

CTI 2500-RIO-B Installation and Operation Guide V1.4
TABLE OF CONTENTS
CHAPTER 1. DESCRIPTION ___________________________________________________ 3
1.1. Introduction _______________________________________________________________ 3
1.2. Communication Ports _____________________________________________________ 4
1.2.1. Serial Port _______________________________________________________________________ 4
1.2.2. I/O Port _________________________________________________________________________ 4
1.3. Dual-Media and Hardware Redundancy Installations ______________________________ 4
1.3.1. Resetting Standby RBC after Communications Loss ______________________________________ 4
1.3.2. Typical
Installation
of Redundant Remote Bases ________________________________________ 5
1.3.3. Recommended Installation of Redundant Remote Bases __________________________________ 6
CHAPTER 2. INSTALLATION __________________________________________________ 7
2.1. Installation Planning
______________________________________________________ 7
Choosing Remote I/O Media _____________________________________________________________ 7
Selecting a Remote Base Address __________________________________________________________ 7
Setting Module Hardware Options _________________________________________________________ 7
Connecting to Remote I/O Cable __________________________________________________________ 7
2.2. Power Requirements _____________________________________________________ 7
2.3. Unpacking the Module _______________________________________________________ 8
2.4. Configuring the Module ______________________________________________________ 8
Setting the RS232 Port Baud Rate _________________________________________________________ 8
Setting Remote Base Controller Station Address ______________________________________________ 8
Setting the Output State on Communication Loss_____________________________________________ 9
2.5. Physical Installation ________________________________________________________ 10
2.6. Connecting to the RS232 Port ________________________________________________ 10
2.7. Connecting the Remote I/O Cable _____________________________________________ 11
2.8. Operation of LED Display ____________________________________________________ 12
2.9. System Status Words _______________________________________________________ 13
APPENDIX A. REMOTE I/O INSTALLATION GUIDELINES __________________________ 14
Cable Layout Planning __________________________________________________________________ 14
Cable Selection _______________________________________________________________________ 14
Alternatively, Beldon 9860, 9271, and 9182 cable can be used to wire your remote I/O. The table below
gives the cable specifications for these models. ______________________
Error! Bookmark not defined.
Cable Lengths ________________________________________________________________________ 16
Bus termination _______________________________________________________________________ 18
Laying Cables Outside of Control Cabinets _________________________________________________ 19
APPENDIX B. I/O “SAFE STATE” OPERATION ___________________________________ 20