Aerial work platform
ZED 20.3 HV
5
COD. UM0284_GB | REV. 0.0 | ED: 09/17
Chapter 4
GB
CONTROLS
5
Three-position spring-return to centre selector switch, rotates the turret.
•
Keep the selector in the up position to rotate the platform to the right.
•
Keep the selector in the down position to rotate the position to the left.
6
Red “command block” indicator;
•
Flashes when the controls in the basket are blocked.
7
Green voltage presence indicator;
•
switches on when the electrical system is powered;
8
Proportional movement speed control lever;
•
operating the lever after implementing the desired command (1, 2, 3,
4, 5, 6) carries out the movement proportionally.
9
Three position key selector switch:
•
Turn the key to the right to enable the mobile control console.
•
Turn the key to the left to enable the controls in the working platform.
•
Turn the key to the central position to disable the mobile control
console.
10
Three-position spring-return to centre selector switch, controls the motor.
•
Keep the selector in the up position to start the motor.
•
Keep the selector in the down position to turn off the motor.
11
Emergency stop button.
•
pressing the emergency stop button disables all the controls and the
vehicle engine switches off
12
Console fastening system;
•
The control console can be removed by unscrewing the two fastening
elements on the control box.
CAUTiOn
The working platform should only be controlled from the mobile control panel
in case of an emergency.
refer to the chapter regarding emergency manoeuvres.
CAUTiOn
The stabiliser indicator lights come on when the plate has reached its minimum
extension and is in contact with the ground, but they do not indicate that the
machine has been properly stabilised. Use the spirit level to check that it is
positioned correctly.
