Chapter 15
GB
OPTIONAL EQUIPMENT AND ACCESSORIES
Aerial work platform
ZED 20.3 HV
1
COD. UM0284_GB | REV. 0.0 | ED: 09/17
15
optional eqUipMent anD
accessories
15
Optional equipment and accessories
15.1
Dead-man-control: pedal in the basket on the work platform
The machine can be equipped with a pedal in the basket system on the work platform.
This accessory, if not pressed, deactivates all the manoeuvres of the control board. In order
to use the control board, you first have to press the pedal and then you can perform the
manoeuvres you require using the proportional levers.
15.2
5000V insulated work platform
The machine may be equipped with a 5000V insulated work platform.
For more information and technical data consult the manual that is integral part of the
machine.
15.3
Auxiliary electric motor
The platform may be equipped with an auxiliary electric motor
M2
. The platform can be powered
either by the engine of the vehicle or by the auxiliary electric motor.
The controls are located on the bed of the vehicle (see section 4 Controls), on the opposite side to the
stabiliser controls, and allow the platform to be used without having to enable the system from the cab.
The electric motor, which is independent from the vehicle on which it is installed, must be connected
to an external power supply (220V), via the socket (7).
It can be used under any conditions. It is especially recommended to be used in the case of:
•
A vehicle engine breakdown
•
A fault in the hydraulic motor connected to the vehicle engine
•
Work to be undertaken in closed places (tunnels, warehouses etc.), to prevent exhaust gas being
emitted to the environment.
If possible, place the vehicle next to the point you have to reach and prepare the work platform for use.
•
Switch off the engine of the vehicle
•
Put the gear lever in neutral.
•
Pull the parking brake.
•
Connect the electric motor to an external 220V electricity supply via the socket (7)
