Aerial work platform
ZED 20.3 HV
3
COD. UM0284_GB | REV. 0.0 | ED: 09/17
Chapter 2
GB
SAFETY
the limitations on use are described in the manual
Any mode or condition of use that does not fall within the limitations of use described in this manual
and not intended by the manufacturer is forbidden.
DAnGEr!
•
It is forbidden to exceed the limits indicated in the technical data.
•
It is forbidden to use the lifting platform in a manner other than that for which it
was intended and designed.
2.2.1
Non-permitted use
DAnGEr!
The manufacturer declines all responsibility for damage to property and/or injury
to persons caused by failure to observe the following warnings.
iT iS STriCTlY PrOHiBiTED TO:
•
lift loads or perform oblique lifts.
•
use the lifting platform to push and/or pull objects.
•
take accessories or pieces of equipment onto the platform that are classiied as dangerous (e.g.
lammable, toxic, explosive materials etc.) because of their chemical-physical characteristics.
•
load the platform when it is raised.
2.3
Obligations and requirements
DAnGEr!
failure to comply with safety standards could cause serious injury or even death.
CAUTiOn
Applicable national standards and legislation, safety standards set down by the
employer and those relating to the work area should all be observed.
read and ensure you have understood the safety standards before reading the
following chapter.
DAnGEr!
The manufacturer declines all responsibility for damage to property and/or injury
to persons caused by failure to observe the following warnings.
CAUTiOn
Tampering with PPE and/or removing the lead-sealed and painted seals is
strictly prohibited.
2.3.1
Electrocution hazard
This machine is
nOT
electrically insulated and does
nOT
provide protection
from contact with or when in proximity to electric power lines.
Observe the minimum safety distances required by the current national
regulations or, in their absence, refer to the minimum distances indicated in the
table at the side (ref. ISO 18893: 2014).
