MNX10030 Rev 0
8/20/2008
6
Power
AC power for the small enclosure and the large enclosures (for both XE150 and
XE150T) enters the enclosure through a ½” conduit fitting and is connected
directly to the power supply.
Signal Conditioner Configuration
Refer to MNX10020 for configuration specifications and procedure for SC200
signal conditioners.
Once all wires are connected, apply power to begin operating the Signal
Conditioner(s). Make sure the status light is indicating normal mode on each
SC200.
Operating Procedure
To operate the Signal Conditioners inside the enclosure, make sure that all wires
are properly connected, then apply power.
CAUTION: Make sure that power input does not exceed specified
limits or damage to the system may result. See Table 1.
Calibration
The Signal Conditioner is calibrated internally during power up. The digital
calibration eliminates the need for any adjustments to the Analog Output.
Section III
Operation
Figure 5. Enclosure Wiring Locations
