20
PPP over Ethernet (PPPoE)
Figure 19: WAN Connection, PPPoE Configuration
To configure the PPPoE settings:
Enter the Use
r’s PPP
Username
and
Password
Enter the
Service Name
if any
Select the
Authentication Method
used during negotiation, default is AUTO.
Check to
Enable Fullcone NAT.
The device will process all requests from the
same internal IP address and port are mapped to the same external IP address
and port
Check
Dial On Demand
if you do not need PPPoE connection always ON and
enter the timeout value (1-4320 minutes) to disconnect the PPPoE connection
when connection is idle and timeout.
Check the
PPP
IP extension
if your ISP requests to enable it, otherwise do not
select it. This is a special service to forward IP address assigned by remote to
the local device in the LAN.
Check the
Use Static IP address
and enter the
IP address
if your ISP assigns a
fixed IP address to you. Otherwise, do not select it.
Check to
Enable PPP Debug Mode
to get more debug message for analysis if
necessary
Check to
Enable Bridge PPPoE frames between WAN and local ports
if
necessary
Check to
Enable Multicast IGMP Proxy
if necessary
Click
Next
Содержание GW-632FW
Страница 1: ...I GW 632FW Active Ethernet IAD with VoIP Wireless LAN and Gigabit Ethernet Switch...
Страница 21: ...16 Figure 13 Device Voice Status...
Страница 91: ...86...
Страница 92: ...87...
