CTC Union FMUX04, Руководство пользователя, Страница: 9 / 62

Chapter 1: Introduction
9
When the
FMUX04
is ordered with optional Order Wire , a hardware card is installed inside
the unit. The front panel's RJ-11 jack provides a "hot line" between the two
FMUX04
units in
the link. Standard telephones may be connected to the RJ-11 jacks and when a phone is taken
"off hook", the remote side will automatically ring. Once answered, both parties may talk
normally. Following the conversation, both parties will place the phones back "on hook" and
the system is again ready for any direct line calls.
Included within the
FMUX04 system unit is integrated optical BERT (Bit Error Rate Tester).
This feature provides a built-in pattern generator and receiver. The BERT function is
designed to run "in-band" allowing BER Testing and data transmission to co-exist on the fiber
media. This allows the BERT function to be running constantly even while the unit is in
service, without effecting normal customer data transmissions. The status of the error rate on
the optical connection may then be monitored via LED indicators on the front panel of the
FMUX04
.
1.3 Features List
•
Simple DIP switch or serial console setting.
•
AC or DC models
•
Non-redundant fiber for multi-mode and single mode, 2 to 120KM.
•
Transceiver options include ST™, SC, FC, or LC. WDM (Wave Division Multiplexing)
•
RJ-45 and BNC connectors for E1 and T1 connection.
•
ITU-T G.703, G.704, G.732, G.733, G.823 and G.824 compliant.
•
Fully transparent framing and timing.
•
In band remote configuration supported.
•
Optical and Electrical loop backs.
•
Local and remote upgrade supported.
•
Full time integrated Optical BER tester constantly monitors optical transmission.
•
Order Wire (FXS) option.
•
SNMP option.
1.4 Packing List
Upon opening your package, please check and be sure it contains the following items:
1. FMUX04 unit, AC or DC depending on modem ordered.
2. DB9F to DB9M, 1 meter, serial cable for console configuration.
3. User's Guide (hard copy or CDROM)
4. CDROM with MIB file (if SNMP option installed)
5. Clover Leaf to local power connector AC cable.
If any of these items are missing, please contact your distributor.