CTC Union 380 S 18, Инструкция по установке и обслуживанию

Страница: 40 / 44

40 CTC 380 S
General information
9.5 Boiler Cleaning
The boiler must be currentless by the boiler cleaning!
• The combustion chamber is from the front easily cleaned:
• Remove the burner hood.
• Switch off the burner.
• Pull out the burner Eurostecker.
• Undo and remove the burner door screws. The door may now be
swinged out without dismantling of the burner.
• Remove the turbulators.
• Clean the combustion chamber and heating surfaces by using the
supplied tube brushes.
• Reassemble the turbulators, close the burner door and put back the
screws and tighten after finishing the cleaning.
• Connect the burner Eurostecker and switch on the burner.
• Attach the burner hood.
The boiler installation must be regularly cleaned according to existing
regulations.
9.6 Drainage
The boiler must be currentless upon drainage. The drainage connection/
drain valve is low located on the rear side of the boiler. By drainage of the
whole system must the heating circuit mixing valve be fully open. In a closed
system air must be supplied.
9.7 Oil operation
General information: Adjustments and maintenance of the oil burner must
always be performed according to the technical manual of the burner.
In order to secure that the installation operates correctly, has low energy
consumption and minimizes the harmful emissions, is it of great importance
that maintenance with a check control in consideration of the setting values
is performed on a regularly basis (recommended annual).
!
If you have questions concerning maintenance or any product defaults, please adress
to your installer.