CSI Wireless DGPS MAX, Справочное руководство

Страница: 140 / 176

DGPS MAX Reference Manual
120
6.3 Selecting a Previously Saved
Configuration
The beginning of the Configuration Wizard starts with a prompt to ask if
you wish to use a previously saved configuration. If you do not wish to,
simply choose ‘No’. If you have created a configuration previously, saved it
to one of the five memory locations, and wish to recall that configuration,
choose ‘Yes’.
When choosing ‘Yes’, the menu system will display the five memory
locations and allow you to choose one configuration, or exit the Wizard
with no changes to the current configuration.
6.4 Bypassing a Configuration Step
The Wizard process prompts you for each step by asking if you wish to
configure the specific parameter mentioned. You may choose ‘No’ and go
on to the next step, thus bypassing the current step.
When bypassing the current step, the parameter that was bypassed will
remain unchanged from your current configuration. For example, if the
DGPS MAX is operating in WAAS mode, and during the Wizard step-by-
step process you are prompted to choose the DGPS source, if you are
happy with the current WAAS mode, select ‘No’. This will maintain
WAAS mode and allow you to proceed on to the subsequent configuration
parameters in the Wizard.
6.5 Completing the Step-by-Step Process
When completing the Configuration Wizard, by pressing the button
with
Finish@
in focus, the Wizard will indicate that it’s configuring the
DGPS source, followed by configuring the receiver. This will complete the
step-by-step process and takes a few seconds. You will then be prompted
to save the new configuration for later use, if desirable.