48
cod. 6118005 ed. 06-2021
10.4 CLEANING AND MAINTAINANCE OF OTHER PARTS
By the user
Clean any dust deposited on the bottom of the fuel loading container every two months.
Check the whole stove is in good condition.
Check the burner combustion chamber is undamaged.
Check all seals are in good condition and are not showing any wear.
Check that the glass on the hearth door is not damaged (e.g. chipped).
If necessary, clean the “T” at the base of the fume duct and the pipe horizontal section, if any, at least once a month
Inspect the combustion air inlet on the back of the stove at least once a month. Remove any dirt as required
Carried out by an authorized engineer (annual cleaning)
Check all mechanical elements are working correctly.
Check and clean the flue.
Carefully clean the stove flue gas pass as
shown in the figure. After moving the tur-
bulators vertically by means of the special
handles
(A)
, rotate each single pin
(B)
using
a screwdriver and a hexagonal insert.
A
A
B
B
Check and clean the pellet unloading duct.
Check sleeves, gaskets and electrical cables are undamaged.
Check and clean the fume fan and its relative seat.
Check and lubricate the bushings of the fuel loading auger and of the burner.
Check the magnesium anode of the water heater
For any other operation not mentioned in this list, please refer only to the CS THERMOS service
centre.
If, while cleaning, the user notices any anomalies, contact CS THERMOS service centre straight away
and do not use the equipment for any reason.
