6
D)
If the door does not close satisfactory (does not revert or does not secure properly) you may proceed as follows:
E)
In case that a service must take place in the compartment of the engine,
note that it is necessary to be done by a
qualified technician
and proceed as follows:
Remove the metal grill panel from the appliance following the instructions in paragraph 9.
Unscrew the two screws that hold the sliding engine base, which are located at the front, just behind the grill panel.
Pull towards you the engine base
without moving the appliance.
Proceed to the service of the engine.
After you have finished, repeat the steps in the inverse order so that your appliance gets back in operation.
F)
If the feed cable is damaged, it must be replaced by the manufacturer or a qualified person from the service
department, or by similarly specialized personnel, in order to avoid danger.
G)
Do not cause any damage to the cooling circuit by the intervention of unauthorized personnel. Advise the
manufacturer and assign such works only to specialized technicians.
NOTE: Our Company has an organized network of qualified technicians throughout Greece. For any maintenance
or operation problem, contact your retailer.
Keep this booklet as well as all documents provided with your appliance and read the guarantee terms carefully.
Place a sharp object - such as a small screw driver, stabber,
nail etc - in one of the holes which are located at the top of
the torsion bar, which is located on the upper side of the door
under the top hinge.
By applying resistance with the stabber
, unscrew with the
screwdriver the kingpin which is screwed on the top of the
torsion bar (figure 9).
ATTENTION, HOLD THE SHARP
OBJECT STEADY TO AVOID AN INJURY BECAUSE
THE SPRING IS UNDER TENSION.
By using a sharp object, turn the top of the torsion bar
anticlockwise until you are able to screw promptly the
kingpin in the next hole. After you screw the kingpin remove
the sharp object.
Examine if the door secures satisfactorily following the above
mentioned procedure. If not, repeat the above steps.
TOP OF
TORSION BAR
DOOR
SHARP
TOOL
CANOPY
KINGPIN
SCREW
DRIVER
HINGE
Figure 9
