Crystal Vision
Using the active front panel
4 Using the active front panel
This operational guide assumes that the panel has been setup according to the
panel set-up procedure described in the Crystal Vision Control Panel manual.
Note:
It is
ESSENTIAL
that the panel set-up procedure is followed and any old or
unknown passwords cleared prior to using the panel for the first time.
At power up, the two lines, 20-character screen will display ‘Crystal Vision’
followed by the firmware version number for the control panel. All eight
control panel keys LEDs will illuminate.
The Crystal Vision control panel start up display
'Control Panel' then briefly replaces the version number display.
If the control panel firmware has been updated for Statesman control
(version 1.5.0 or higher), Statesman Mode will be entered and the message,
‘Press CAL to Exit’ will be displayed and the CAL LED will light.
Statesman mode is entered by default
To continue with control panel operation or configuration, press the CAL key
once. A second press of the CAL key will return to Statesman control.
REFGEN User Manual R2.0
12
11 January 2019
