R, P, & G Series
On Cook & Cold and Hot & Cold models the reservoir can be removed easily by following the steps
given below.
1. Unplug (Figure 28) and approach the cooler from the front.
2. Remove the water bottle (Figure 29) and drain water from the reservoir and hot tank, remembering
to cool and drain hot tank. Allow 1 hour for hot water to cool down inside the hot tank before
removing the drain plug at the rear of the cooler to drain into a bucket (Figure 30 and Figure 31).
3. Use the fingertips of both hands to press downward on the Cone and turn counter clockwise till it is
TM
free from the cooler opening. (Figure 32 and Figure 33) then remove the DryGuard
(Figure 34).
4. Using fingers of both hands loosen and remove the insulation jacket covering the plastic reservoir
from the cooler opening (Figure 35 and Figure 36).
TM
TM
Note: The DryGuard lid is standard on the Summit cooler. See the DryGuard section for
installation and removal instructions.
(Note: On Hot & Cold models, after step4
unscrew the round plastic one piece baffle Figure 37)
Figure 28
Figure 29
Figure 30 Figure 31
Figure 32
Figure 33
Figure 34
Figure 36
Figure 35
Figure 37
O
P
E
N
O
PE
N
