!
5
WARNING
This stove is fitted with a spillage monitoring system consisting of a thermal switch, which shuts
the appliance off in the event of a blocked flue or inadequate flue pull occurring. The system shall
not be adjusted by the installer or shall not be put out of action. When the spillage monitoring
system is required to be replaced, only original manufacturers parts shall be used.
If the stove switches off for no apparent reason, the appliance should not be used until expert
advice is obtained and the fault rectified
All surfaces, except the control valve, are working surfaces and become very hot in use. They
must not be touched or any combustible materials put on them
It is recommended that a fireguard complying to BS 8423 should be fitted for protection of young
children or elderly or infirm persons.
The door handle has to be removed to remove the glass allow to cool before removing this
as it will become very hot and is a working surface in use
2.0 INSTALLATION
2.1 HEARTH
The stove must be installed on a non-combustible hearth with the hearth material being at least
12 mm thick the hearth must protrude at least 150 mm (6”) in front of the stove and be of a size
sufficient to accommodate the stove
2.2 SITING
The stove must not be installed in a bathroom
Clearance from non-combustible material in the fireplace opening must be at least to dimensions
in table below
Position
Non combustible material
Combustible material
Distance mm
Above
100mm
300mm
Back
50mm
300mm
Left
100mm
300mm
Right
100mm
300mm
Fitting the stove any closer to the back may cause Nuisance shutdown of the stove as the airflow may be
compromised and the thermal cut off will operate
