!
20
Below information only the handset will already be paired
Pairing the handset with the gas valve
Ensure the handset and the gas fire control have good batteries inside and the batteries are
facing the correct direction (as shown inside the battery compartments).
Ensure the battery contacts and compartments are clean and free from any contamination.
(The green light on the handset will flash fast when the handset is held (not steady green),
which shows it is ready to accept a pairing from the gas fire control.
(NOTE: Ensure the small slide switch on the top left of the gas fire control is slid to the right (I)
position).
Place the handset within a few feet of the fire ( no need to hold it at the time ).
On the gas fire, simultaneously press the hold the - and + buttons on the gas fire control (i.e.
not the handset) unit the red light on top left of gas fire control begins to flash rapidly,(this will
take about 5-8 seconds), then immediately as the red light starts to flash release the - and +
buttons and quickly and press the power button that is underneath them. (Note: This button
press must be done with 1 second of the red light coming on. If not done quickly enough, then
the above must be repeated until done correctly).
When done correctly, you will hear an audible sound from the handset. Immediately pick up and
grasp the handset as normal to unlock the key pad and then press and hold the “ set “ button
for around 3 to 5 seconds.
When you hear several beeps from the handset as the pairing has been confirmed.
You know the pairing has taken as now when holding the handset the green light will be a
steady green (not flashing when held).
You can now scroll through the settings of the handset adjusting by pr or - to adjust
each setting and move on when set by pressing the set button once all set keep pressing the
set button until you leave the set up menu
More information can be found at www.crystalfires.co.uk
IMPORTANT USER INFORMATION – AFTER INSTALLATION BY THE ENGINEER , READ
THIS BEFORE ATTEMPTING TO OPERATE THE FIRE
NOTE: The handset is supplied paired to the Gas Control. Do not alter the pairing. The
handset is designed to be not too easily operated by accident for safety reasons. If for
any reason the pairing has been altered, then the handset will not work. The handset
needs to be reset and paired again.
