!
15
This stove should not be used for any other purpose than as a room heater and decorative stove, due to its
newness of materials the stove may give off a slight smell for a period of time after commissioning this is
quite normal and should clear within a few hours of use
The installation must be in accordance with the national regulations and must be carried by a qualified
installer EG: gas safe
Under no circumstances should the stove be operated with the glass panel damaged broken or missing, all
surfaces except controls are considered to be working surfaces and will get very hot during and after
use ,if young children, the elderly or infirm are likely to be near the stove a suitable fireguard to BS8423
is recommended
A combustible shelf may be fitted above the stove providing the shelf protrudes less than 150 mm in front
of the stove and there is 300mm clearance above the top of the stove
Curtains are not recommended above the stove
Do not drape clothes or any materials over the stove
The stove must stand on a non-combustible hearth and be at least 12mm thick and sufficient size to
accommodate the stove
No purpose provided ventilation is normally required but must be in accordance with national regulations
in force
The fuel should be arranged only as shown in these instructions
Should the stove extinguish for any reason do not relight for a minimum of 3 minutes
All surfaces, except the control valve are working surfaces and become very hot in use, they must not be
touched or any combustible materials be put on them
It is recommended that a fireguard complying to BS 8423 should be fitted for the protection of young
children or elderly or infirm persons
The door handle has to be removed to open the door and get to the glass this is also a working surface
allow to cool before removing
This stove should be serviced regularly at least annually
Only replace ceramic parts or any parts of the fuel bed with parts supplied by the manufacturer for this
stove do not change the fuel bed layout from the instructions supplied
The flue will need sweeping periodically
If the stove fails and the appliance goes to reset the start button will have to be held for 10 seconds to clear
the remote fault
THE STOVE IS FITTED WITH A SPILLAGE MONITORING SYSTEM CONSISTING OF A
THERMAL SWITCH. THIS SYSTEM IS NOT ADJUSTABLE AND MUST NOT BE PUT OUT
OF ACTION & IF REQUIRED TO BE REPLACED ONLY ORIGINAL MANUFACTURERS
PARTS MUST BE USED ( IF THE STOVE SWITCHES OFF FOR NO APPARENT REASON
THE APPLIANCE SHOULD NOT BE USED UNTIL EXPERT ADVICE IS TAKEN )
