Crysalli Beverage Systems
a division of WPD
1739 Sabre Street, Hayward, CA 94545
www.crysalli.com
510.732.0100
Countertop Chilled
Water Dispenser Quick
Installation Guide
Cylinder pressure. If needle drops into
“red area” cylinder is empty. Change CO2
cyllinder.
To adjust high pressure regulator: Loosen
the locking nut using a regular screwdriver,
turn adjustment screw clockwise to
increase pressure; counterclockwise to
decrease. When needle is positioned at the
right pressure, tighten locking nut.
Set gauge
75 PSI
CO2 Pressure to
carbonator tank in unit
Plastic
washer
Secure line to regulator by
tightening nut
Lock nut
Adjusting screw
CO2 Line from regulator to
carbonator tank inside unit
Remove lid & fill
water bath to top of
stand pipe
Drain hose to floor drain
Condensation will build inside unit & must
drain or unit will overflow
Note: Carbonation levels will be low until the machine
has developed a sufficient ice bank to reduce
temperature of dispensed drink.
This can take up to 4 hours.
3/8” SS hose barb
Water line connection to filter.
Note: make sure water pressure is 50 PSI
or less, if higher use in-line water pressure
regulator.