1. Select a location for you chilled
water dispenser, keeping in mind
the unit needs air space behind
it and to the sides. Place unit as
close as possible to water filter
connection & 120-volt electrical
outlet.
2. Mount the Water Filter System
vertically with the filter hanging
down, in an accessible location
leaving 2.5” of space below the
cartridge for easy replacement.
The CR-14FC filter system has a
3/8” fpt inlet and outlet, so use
fittings appropriate to the hose
size or angle stop you are drawing
water from. Plumb Leak Block
device after angle stop.
3. This unit comes with a 50 PSI
water pressure reducing valve
(WPRV) supplied with 3/8” JG
push in fitting. Plumb this WPRV
in after the water filter system
with the arrows in the direction
of water flow. You can use one
of the 6’ sections of 3/8”OD hose
to connect from the filter to the
WPRV. Push the hose end into the
fitting till it stops, you can then
pull lightly on it to confirm it is
tight.
4. Use the other 6’ sections of 3/8”
OD hose on the outlet of the WPRV
to then connect to the CP-2000-
CT2. The CP-2000-CT2 has a short
water inlet hose off the bottom of
it with a 3/8 JG push-in fitting end.
Connect the water inlet hose from
the WPRV to this fitting.
5. Connect a high pressure CO2
regulator (CR-PC160) to CO2
cylinder then connect “CO2” line
from unit to regulator. The “CO2”
line is the ¼” braided hose with a
stainless steel nut on the end of it.
6. Turn on water. Check connections
for leaks and flush the water filters.
7. Open CO2 by turning knob on
tank. Adjust regulator between 55-
75 PSI. And check for leaks.
8. Run clear overflow drain hose to
floor drain or other waste drain.
9. Fill water bath: Remove lid and fill
water bath with non-filtered tap
water, fill up no less than ¼” to
top of white standpipe. This is the
vertical white tube in the water
bath that is connected to the clear
overflow hose.
10. Plug unit power cord into 120-volt
outlet. Toggle the on/off rocker
switch to the “on” position. Fan
and compressor will turn on. Fan
and compressor will automatically
turn off when a complete ice bank
is made and cycle on and off to
maintain it.
11. Unit will take between 3 & 4 hours
to make a complete ice bank.
12. Pull open the still water and
sparkling water faucets to run
water through the system. You will
need to run the sparkling water
faucet for several minutes to cycle
the carbonation system before full
sparkling water will dispense.
13. Once unit has built the ice bank,
you are ready to dispense chilled
still and sparkling water.
Crysalli Beverage Systems
a division of WPD
1739 Sabre Street, Hayward, CA 94545
www.crysalli.com
510.732.0100
CP2000-CT2 Quick
Installation Guide
Instructions
