Installation
Mounting the Display Console
Select a mounting location which seems most workable,
and that best fits your needs. It should be convenient to
reach and highly visible to the operator. DO NOT INSTALL
IN A POSITION THAT OBSTRUCTS THE VIEW OF THE
ROAD OR WORK AREA. Whenever possible, avoid
locations that expose the console to direct sunlight, high
temperature, strong chemicals or rain. Place the mounting
bracket in selected location, mark holes, drill 1/4” (7mm)
holes and mount bracket with bolts, lockwashers and nuts
provided. (Use self-tapping screws if not practical to use
bolts.) See Illustration 1A. Put rubber washers on carriage
bolts and put the bolts through the bracket holes from the
inside out. Loosely attach the mount knobs onto the bolts.
Place console over carriage bolt heads and tighten knobs to
secure the console.
See Illustration 1B.
5. Attach the quick disconnects on the switch harness
to the switch. The RED wire should attach to the top
connection with the BLACK attaching to the bottom
connection.
6. Install the switch harness connector into the mating
connector (gray tie) on the console harness.
NOTE: If using the included Power On/Off switch
instead of the ignition switch connection, install
the power switch as described above. Connect the
power switch cable connector (2 pin) to the mating
connector on the console harness.
Mounting the Run/Hold Switch Kit
Remove the mount knob from either side of the console.
Install the bracket over the carriage bolt and along side
the console bracket. Install the mount knob on the carriage
bolt and tighten to secure the console and run/hold switch
bracket in place.
Install the switch into the bracket using the steps below:
1. Place the small washer on the switch followed by the flat
“notched” washer. See Illustration 2.
2. Secure the washers in place with one of the hex nuts.
3. Peel the back from the decal and secure to the front of the
switch bracket. See Illustration 2.
4. Install the switch in the bracket and secure in place
with the remaining hex nut.
NOTE: Make sure the “ON”
connector is at to top.
Attaching the Power and Run/Hold Control Switches
CrustBuster
DrillMaster Quick Start Guide
346-001150
Pg 2
Revised 4/2/2010
