Welcome to the mounting instruction sheet for the Crumar D9U Drawbar
Controller kit. To assemble this kit correctly and set it up to work
properly, a certain skill with electronics and computers is required, plus
some tools and a little bit of patience and attention.
REQUIRED TOOLS
1. Soldering iron, preferably a temperature-controlled 60W iron with a
1,5 ~ 2,5 mm wide tip;
2. Solder, preferably good quality 0,8 ~ 1 mm diameter;
3. Good quality cutters;
4. Phillips screwdriver;
5. A computer with Arduino IDE installed.
PREPARATION
Prepare a clean and tidy surface, with just the required tools handy and
make sure you have discharged your body from electrostatic charge by
touching some metal object that makes contact with the floor. Optionally,
wear an ESD wristband.
WHAT'S IN THE KIT
- 1x PCB Drawbars v11_2018
- 1x PCB DB_CM_V11
- 1x Arduino Pro Micro (Leonardo clone)
- 1x Metal bottom piece
- 1x Metal top cover
- 9x Drawbars
- 2x Brown Caps
- 3x Black Caps
- 4x White Caps
- 4x 220ohm 1/4W resistors
- 1x Red 3mm LED
- 1x Yellow 3mm LED
- 1x 2x8 DIL Strip
- 1x TRS 3.5mm Jack connector
- 1x Angled Tactile Switch
- 2x M3X12 Black screws
- 2x M3 Spacers
- 2x M3 Bolts
- 22x M3X4 Black screws
- 9x M3X6 screws
- 1x USB – MicroUSB cable
- 4x Adhesive rubber feet
