
Boat Handling and Operation
3-29
Owner’s/Operator’s Manual
Trim Tab Controls
Push the trim tab rocker switches in half-second bursts. Holding the rockers down too
long will over-trim the boat.
The trim tab switches are used to correct the trim of your boat while you are
underway.
•
To trim the bow of your boat down, push the top halves of both switches.
•
To trim the bow of your boat up, push the bottom halves of both switches.
Refer to
Trim Tabs
.
Voltage Gauge
The voltage gauge monitors battery condition and alternator performance. Under
normal engine running conditions (1000 RPM or higher), the voltage will range
between 12.0 to 15.5 volts when the alternator is charging. The batteries are fully
charged if the voltage gauge reading is high when the engine is not running and the
ignition key or switch is ON.
Significantly higher or lower readings show a battery problem, alternator malfunction
or heavy drain on the battery. An oscillating reading shows a loose wiring connection
or loose belts. Displayed low voltage readings after stopping engine shows a bad
battery or large battery load.
Wash-Down Pump Switch
The wash-down pump switch controls the ON or OFF operation mode of the wash-
down shower pump. To prevent damage to the pump, make sure both the seacock
and the shower wand, or spigot, is open before turning ON the system.
Windlass Switch
The windlass switch controls the ON or OFF operation mode of the windlass. Refer
to the manufacturer’s literature for more detailed information.
Windshield Wiper Switch
The windshield wiper switch controls the ON or OFF operation mode of the
windshield wiper.
Crownline_OM_sec3.qxp 11/13/2006 8:33 AM Page 3-29