Crown DCi 4 1250DA, Руководство по эксплуатации

Страница: 10 / 59

page 6
DriveCore Install DA Series Operation Manual
Software Setup
Software Setup
Setup and configuration of the DriveCore Install DA Series amplifiers can be completed through HiQnet Audio Architect
TM
. The amplifier should be connected to a TCP\
IP network via the Ethernet connection on the back of the amplifier. Note that the Dante digital audio transport connectors cannot be used for control and monitoring of the
amplifier.
To quickly configure your DriveCore Install DA amplifier, connect all of the amplifiers and configuration computer to the same network. For more information on network
configuration, please visit http://audioarchitect.harmanpro.com . In the following example, we will only show amplifiers.
When Audio Architect is first loaded, the software will scan the network for HiQnet devices. All devices that are discovered on the network will be found under the ADD
DEVICES tab on the left hand tree menu. If the devices are not found, then the network may not be configured correctly. See
Figure 7
.
Figure 7: Add Devices tab tree menu
NOTE: Illustrations and some text references are for channel pair 1–2 and 3–4 only. Note that channels 5–6 and 7–8 can be programmed in the same manner, and each
channel may be configured independently.