Crossfire Invercut 40D, Руководство пользователя

Страница: 8 / 21

7
Plasma Cutter
Operating Instructions and Parts Manual Plasma Cutter
Invercut 40D
Cutting Torch Connection
The Cutting Torch Connect the negative(-) on the front of the plasma cutter.
Power switch
It is the on/off switch. After the machine is connected to the input power supply,
turn on this switch. The power indicator on the front panel will turn on.
Power cord
Plug this unit into a 120V or 230V, 40 amp circuit breaker power supply.
breaker power supply.
Current Adjustment
Variable adjust the output cutting current. The higher output matches the thicker
metal. The maximum cutting thickness is up to 3/8
″ for this unit. Please note that
the maximum cutting thickness varies depending on the material type you are
cutting. See the following table for reference.
Material Clean Cut
Mild Steel 3/8"
Stainless Steel 1/4"
Galvanized 1/4"
Aluminum 1/4"
Copper 1/8"
Brass 1/8"
INSTALLATION
1. POWER REQUIREMENT
AC single phase 120V or 230V 50/60HZ fused with a 40 amp time delayed fuse
or circuit breaker is required. DO NOT OPERATE THIS UNIT if the ACTUAL
power source voltage is less than 100 volts AC or greater than 260 volts AC.
• High voltage danger from power source! Consult a qualified electrician for
proper installation of receptacle. This cutter must be Grounded while in use
to protect the operator from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Do not use
any adapters between the cutter’s power cord and the power source
receptacle. Make sure the POWER switch is OFF when connecting your
cutter’s power cord to a properly grounded 120V or 230 VAC, 50/60Hz, 1
phase, 50amp input power supply.
2. EXTENSION CORD - We do not recommend an extension cord because of
the voltage drop they produce. This drop in voltage can affect the performance of
the welder. If you need to use an extension cord, we recommend you check with