CCpilot V700
Revision: 1.0
Technical Manual
2020-09-10
www.crosscontrol.com
6
Figure 3: CCpilot V700 rear side view
3.3.
Connector side view
At the side of the device there are external interface connectors, i.e. 3 x M12 for Power, CAN,
Ethernet and USB.
4.
Mounting and handling
This chapter contains recommendations for installation, handling and maintenance of the
product.
4.1.
Mounting
CCpilot V700 supports two different mounting methods, a RAM mount or a panel mount. These
two mounting methods are described separately below.
For both fastening methods, use the appropriate 3 pc. M5 x 0.8 button head screw of type MRT
(Torx) The recommended torque for the screws is 1.5-2.0 Nm. Using fluid locker or locking
washers (split ring, toothed lock, etc.) is required for proper mounting. Ensure that the M5
mounting screws are clean and dry before mounting.
GORE-TEX
membrane, under
mount for added
protection
Figure 4: CCpilot V700 connector side
Ethernet
Power and CAN
USB
