CCpilot V700
Revision: 1.0
Technical Manual
2020-09-10
www.crosscontrol.com
18
6.
Interface overview
This section describes the various interfaces of the product. Main part of these interfaces can
be accessed via software APIs. These are described in the CCpilot V700 Software Guide.
6.1.
Front panel
6.1.1.
Touch screen
The front panel contains a projective capacitive (PCAP) touch screen, which is capable of
handling two simultaneous touches.
6.1.2.
Light sensor
There is a light sensor in the front panel used by user applications or used with the built-in
automated function for dimming of the display brightness.
For light sensor location, see Figure 2. Refer to the CCpilot V700 Software guide for details
about accessing the light sensor data from user applications.
6.1.3.
RGB status LED
The
CCpilot V700
contains a status LED in the front used for notification while starting up, shutting
down or in other operational states.
6.2.
Buzzer
The CCpilot V700 has a built-in buzzer that can be used for audible notifications. The buzzer is
software controllable with configurable volume and frequency.
For buzzer location see Figure 3. See chapter 5.5 for buzzer notification events. Refer to the
CCpilot V700 Software guide for details about controlling the buzzer from user applications.
6.3.
CAN
The CCpilot V700 has two CAN ports that meets CAN ISO 11898 2.0B (29-bit extended
identifier) and supports bit rates up to 1 Mbps.
Note that Internal EMI filters on CAN High/Low signals have a capacitance of 100 pF (typ)
which deviates from the ISO 11898 standard and implies some limitations on the CAN bus
topology (maximum bus length, number of CAN nodes etc.) when running at high bit-rates, i.e.
above 250 kbps.
The ports feature highly protected CAN transceivers which are tolerant for bus short-circuits to
main supply voltage and ground.
CAN shield connections are according to J1939-11 with capacitive coupling to ground. There is
no device-internal CAN bus termination, therefore bus termination must be applied externally.
6.4.
Ethernet
CCpilot V700 has one Ethernet interface supporting 10BASE-T/100-BASE-TX/FX and Auto-
MDIX.
The Ethernet interface is galvanic isolated with 1.0 kV
AC
insulation voltage.
