Cross Technologies 3116-T31-148, Инструкция по эксплуатации

Страница: 9 / 22

2.2 Rear Panel Input / Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.
AC - POWER IN
AC input for switching power supply.
100-240 ±10% VAC, 47-60 Hz.
AC
GND
J5 - RF OUT
3.7 - 4.2 GHz
7.25 - 7.75 GHz
11.7 - 12.8 GHz
SMA female connector.
See Table 2.2 for other options.
J4
10 MHZ REF
OUTPUT
J10
AND
MONITOR
CONTROL
5 4 3 2 1
9 8 7 6
J10 - MONITOR AND CONTROL
DB9 female connector.
See Table 2.1.
J3
10 MHZ
EXT REF INPUT
RF OUT
J5
J3 - 10 MHz EXT REF INPUT
10 MHz external reference input,
+2 to +8 dBm, 50/75 ohms,
BNC female connector
J4 - 10 MHz EXT REF OUTPUT
10 MHz reference output,
+4 ± 3 dBm, 50/75 ohms,
BNC female connector.
J7 J2
J7 - ETHERNET
CONNECTION (Option W8)
RJ45 Ethernet Connector
RF MON
J1 - RF IN
5.925 - 6.425 GHz
7.90 - 8.40 GHz
13.75 - 14.85 GHz
SMA female connector.
See Table 2.2 for other options.
J1
RF IN
J2 - RF MONITOR
SMA female connector.
See Table 2.2 for
other options.
FIGURE 2.2 3116-T31-148 Rear Panel Inputs and Outputs
TABLE 2.1 JJ10 2.1 J10 Pinouts (RS-232C/422/485*)
Pin Function
1 Rx-
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Tx-
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
TABLE 2.2 2 IF/RF 2. 2 IF/RF Connector Options Connector Options
Option IF RF
STD BNC, 50 Ω Type N, 50 Ω
-S BNC, 50 Ω SMA, 50 Ω
-N BNC, 75 Ω Type N, 50 Ω
*Interface: DB-9 Female
Protocol: RS485, RS422, or RS232C (selectable),
9600 baud rate, no parity, 8 data bits, 1 start bit, 1 stop bit
3116-T31-148 Manual, Rev. C Page 9 04/22/2015