2.6 Menu Settings
All program changes must start with the operation of the Menu/Execute switch and must also end with the
operation of the Menu/Execute switch verified by the “Save Settings?” Menu. If this sequence is not followed,
none of the changes will take effect. If programming is initiated and no operator action takes place for
approximately 30 seconds (before the final press of the Menu/Execute switch) the display will revert to its
previous status and you will need to start over.
Alarm indications appear on the LEDs (See figure 2.3). An alarm condition will occur if any local oscillator
phase lock loop (PLL) comes out of lock. The Remote LED will light when you select the Remote mode.
OTHER SETTINGS
EXT REF = INT
SAVE SETTINGS Y N
SCROLL <>
SCROLL
SCROLL <>
SCROLL
SCROLL <>
SCROLL
SCROLL <>
SCROLL
SCROLL <>
SCROLL
OTHER SETTINGS
REF OFFSET = +0000
OTHER SETTINGS
REMOTE = ON
OTHER SETTINGS
INTERFACE = RS232
RS485 ADDR = 00
R
R
R
R
R
PUSHING MENU/EXECUTE SEQUENCE
ON POWER UP
SCROLL <>
SCROLL
Power Up
IP Address
Normal Display
Menu 1
Select Settings
Menu 2
Set Frequency
Menu 3
Set Gain
Menu 4
Select Spectrum
Menu 5
Set EXT 10 MHz
Save?
When “R” is selected
from any above menu or
at the end
SCROLL <>
NORMAL DISPLAY
2416-425
5.00
WHICH SETTINGS?
#1 #2 #3 #4 OTHER
CH1 DOWNCONVERTER
FREQ= 2000
R
2001.125 2110.500
2210.000 2301.750
CH1 DOWNCONVERTER
EXT 10MHZ REF OPT-E
SCROLL <>
SCROLL
SCROLL <>
SCROLL
SCROLL <>
SCROLL
CH1 DOWNCONVERTER
GAIN = +25
CH1 DOWNCONVERTER
SPECTRUM = NON-INV
R
R
R
SAVE SETTINGS Y N
192.168.123.2
REPEAT ABOVE SEQUENCE
FOR ALL INDIVIDUAL CHANNELS
FIGURE 2.5 Menu Display and Sequence
2416-425 Manual
Page 17
11/17/21
