Crosley CR1206A, Инструкция по эксплуатации

Страница: 9 / 16

The unit can be used as an alarm clock, whereby
the selected source (CD, TUNER, USB, SD CARD
OR PHONO) to start playback at a preset time.
Make sure the clock is set before using the timer.
1 In the standby mode, press and hold
TIMER
/ on the remote over 1 second, icon " " and
message” TURN ON” start flashing. Press TIMER
/ again on the remote to begin the “SYSTEM
POWER ON” timer setting.
2 Press FF / or FB / repeatedly to set hours.
3 Press TIMER / on the remote to enter minutes
setting mode.
4 Press FF / or FB / repeatedly to set minutes.
5 Press TIMER / on the remote again to begin
“SYSTEM POWER OFF” timer setting. Icon " "
and message “TURN OFF” start flashing. Press
TIMER / on the remote again to begin timer
setting.
6 Press FF / or FB / repeatedly to set hours.
7 Press TIMER / on the remote to enter minutes
setting mode.
8 Press FF / or FB / repeatedly to set minutes.
9 Press TIMER / on the remote again to begin
setting the source from wake up. Default at
TUNER mode. Message TUNER start flashing.
10 Press FUNCTION / to select wake up source.
The unit will be waked up from last tuned station
if TUNER mode is selected.
11 Press TIMER / on the remote again to
complete timer on/off setting. Icon " " will keep
display on LCD if timer is set.
Note: The wake up sound level will be increased
gently to preset volume level.
12 Press TIMER / on the remote control to turn
on/off the timer. The icon " " will be on/off
respectively.
AUX1 AUX2
AUX1 AUX2
BASIC OPERATION
Basic Operation
SETTING THE TIMER
SETTING THE CLOCK
After connecting the system to power supply, set
the clock first.
1 Press POWER / to switch the unit to Standby
mode
- The display shows the time
- “0:00” flashes by default if you have not set the
clock
2 In the Standby mode, press and hold
PROGRAM / over 1 second.
- The hours digit starts flashing.
3 Press the FF / o FB / repeatedly to set
the hours.
4 Press PROGRAM / again to confirm.
The minutes digit starts flashing
5 Hold down FF / o FB / repeatedly to set
the minutes.
6 Press PROGRAM / again to confirm.
The minutes digit stop flashing, the clock begins
to run.
7 Press PROGRAM / to select between 12
and 24 hours, shown as below
Function select
1 Press FUNCTION / to select among:
2 When the set is on, press POWER / to
switch the unit off. LCD backlight will be turned
off and shown message“GOOD BYE” for 2
seconds, then the STANDBY LED is turned on.
Note: In the standby mode, the tone, sound
settings, tuner presets and the volume level (up
to a maximum volume level of 30) will be stored
in the unit’s memory.
8