Crosley CR1206A, Инструкция по эксплуатации

Страница: 8 / 16

1 Remove packing materials from unit.
Note: Save all packing materials
2 Remote control is located in the outside of the
Styrofoam packaging
3 Remove plastic bag covering radio and remote
control.
4 Untie antenna wire on back of radio.
5 Remove Styrofoam shipping material from
turntable.
6 Remove black tie-wrap from under the TONE
ARM .
7 Remove white protective needle cover by gently
pulling towards the front of the unit.
SET UP
1 Untie the wire on the AC power cord .
2 Press the MAIN POWER button on the back of
the unit to switch the main power on.
3 Press the POWER / button on the front of
the unit to switch the unit to Standby mode.
4 Untie the FM antenna and allow it to hang down
in a straight line for optimum FM reception. If you
have trouble tuning in an FM station, move the
external FM antenna for best reception. Do not
connect FM antenna to outside antenna.
ANTENNA
Basic Operation
UNPACKING
POWER SOURCE
BATTERY BACK UP
Connect the AC power cord to the wall socket. This
system switches to Standby mode automatically and
LCD would shown as below
To switch the unit on, press POWER / LCD
backlight will be turned on. STANDBY LED is turned
off and displayed as below.
The battery backup system to maintain your clock
and alarm settings during a power outage. In the
event of a power outage, the battery backup will
save your time and alarm settings until power is
restored. To utilize the battery backup, you must
install two AAA batteries. The battery backup will
not operate unless batteries are installed. To install
batteries, follow the instructions below.
1 Remove the Battery Compartment cover from
the back of the unit.
2 Install two new AAA batteries in the correct
position as shown inside the battery cover.
3 Reinstall the Battery Compartment cover.
NOTE:
Do not use different batteries
Do not mix old and new batteries
Antenna: for FM reception, the unit is provided
with a FM WIRE ANTENNA , move the wire until
the reception is clear and with no interferences.
For AM reception, the unit is provided with a
directional build-in ferrite antenna. Rotate the set
to find the position in which the best reception is
obtained. Do not connect the EXTERNAL FM
ANTENNA to any outside antenna.
7