Cron TP26G+, Руководство пользователя, Страница: 9 / 31

4.5
.
8 Removal of the device’s “scanning pla orm fixa on bracket”
4 .5
.
9 Removal of the device’s
"
driving rod fixa on bracket”
4 .5
.
10
4 .5
.
11 Cut and remove all secure strips(RED color)
4 .5
.
12 Put back the covers or casing onto the device
4 .5
.
13 Connec ng USB communica on cable to the Computer
4 .5
.
14 Auto Plate Feeder connec on, installa on and alignment of plate entrance with main device
Chapter 4: Offloading, Unboxing and Installing
a) Scanning Pla orm fixa on bracket is located inside the device. Remove the upper rear casing of the CTP. You
may no cethe "scanning pla orm fixa on bracket" (in RED color) inside the right sideof the device;
b) Use a hex wrench to remove the fixing screws of the "Scanning Pla orm Fixa on Bracket" of the device and
pay special a en on when removal; Handle with care and avoid scratches to the Encoder Strip(gold color) that
a ached at the side of the panel along the guide rail
Remove both pieces(L/R) of the "fixing brackets" of
the nozzles suc on arm (on H model), near the front plate
entrance. Remind to keep the hex screws for use to fixing
the loading table later on.
Using an external USB interface cable to connect device and computer, the cable is located in the
lower right side of the enclosure, and it is fastened to ensure reliable connection;
a) Hex screws retained are first used secure onto the reserved front screws holes, but do not
completely tight in
b) Attach the plate loading table to aligned with the hex screws put in before, then secure and tighten
this screws to hold the plate loading table leveled with the main device
17 16
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR