39
38
SIMPLE AND DIRECT
丨
STEADY
丨
MAJOR
SIMPLE AND DIRECT
丨
STEADY
丨
MAJOR
2
、
The right frame, the lower crossbeam and the upper crossbeam are connected,
and theconnec on mode is synchronous 1.
Picture shows result a er assembly
：
3
、
Connect the Auto Loader Table with the le and right frame.
a
）
Use six angle screw M6X12+ to connect the simple auto loader table to the support plate block;
b
）
The gap is located in the non beam measurements
4
、
Screw the front and back sides of the auto loader table with screws.
5
、
Connect the paper collector with the screws on the two sides of the receiving frame
a achments, confirm that the slide is smooth before and a er assembly.
6. A er the installa on is completed, the product should look like in the picture shown
below
(for example, G+ equipment, as shown in Figure
Содержание TP26G+
