CRL 64” BELT SANDER
MODEL BM64B FOR 102 x 1625mm SANDING BELTS
crlaurence.com
●
Toll Free (800) 421-6144
●
Fax (800) 262-3299
CALL TOLL FREE ANYWHERE IN THE U.S. AND CANADA
●
ALL PRODUCTS F.O.B. NEAREST WAREHOUSE
INTRODUCTION
1.1 INTRODUCTION
The CRL Model BM64B is a water cooled Belt Sander intended for the finishing of edges of glass panelsor “lites”. It has been developed
and improved through the years until it can now be called the finest piece of equipmentavailable in its price range for this purpose.The
machine incorporates features such as a direct drive, 1 H.P. motor,a gas cylinder-tensioned upper pulley, safety shields, totally sealed ball
bearings eliminating weekly lubrication, and aunique, rust-proof, thick-walled HDPE (High Density Polyethylene) water tank. It will give best
results if it is properlycared for. It is not necessary to pamper this equipment, but reasonable maintenance will increase the machineʼs lifeand
keep it in a safe operating condition.
We put sealed bearings in our machines because we found that most shops do not take the time to grease the bearings on a routine basis.
However, even sealed bearings do sometimes go bad, and should be inspected on a weekly basis for noise or rough spots. Scrubbing the
machine occasionally will prevent glass and sludge build-up, and any areas where rust is starting to show should be scraped, primed, and
repainted to get the maximum life out of the machine.
The instructions on the following pages will guide you through the unpacking, initial setup, maintenance, and replacement of parts on your
machine. Should you run into any problem or procedure you do not understand, please contact us via e-mail at [email protected] and we
will be glad to help you. Parts and expert advice can also be obtained directly from the CRL at (800) 421-6144.
1.2 UNCRATING THE MACHINE
Move the machine carefully and position it close to where it will be used. Remove the shipping cover and inspect for any damage. If you find
any part of your machine has freight damage, save all shipping material and call the delivering carrier immediately. Tell them you want to file a
damage claim and have them send out an inspector. If everything is okay, completely remove the shipping container, including the wooden base.
Place the machine with sufficient room on all sides to allow for working access to the belt, machine maintenance and inspections.
1.3 IMPORTANT SAFETY INFORMATION
●
DO NOT
operate this equipment unless you have read this manual and are familiar with
the machines operation.
●
NEVER
climb on the machine for any reason. Even if the machine is bolted down, there
is a risk of ijury from falling. No part of it is made to hold the weight of a person.
●
DO NOT
operate the machine without all guards and access doors/gates in place
and closed. Further,
DO NOT
disable any safety lock-out switches.
●
ALWAYS
pay attention to
WARNING
labels placed on the machine.
●
ALWAYS
wear proper protective gear when working with or grinding glass.
●
HEARING PROTECTION MANDATORY.
Wear hearing protection while operating.
●
NEVER
open electrical boxes or components unless the power is disconnected from the
source and locked out.
4
