The Hardware Unit
• The
L
(eft) and
R
(ight)
Out
(put) ports are both 1/4" TS (mono) jacks. They deliver the
left and right audio outputs of your current patch, as scaled by the
Vol
(ume) knob.
• The single
In
(put)
L
R
port is a 1/4" TRS (stereo) jack. It receives any stereo audio input
that you would like fed into your current patch.
NOTE:
If a 1/4" TS cable is connected, any incoming signal will only be received by
the left input.
• The foot
Pedal
port is a 1/4" jack. It is intended to be connected to a keyboard
sustain-/damper-style pedal, which will deliver on/off messages to your patch.
NOTE:
Organelle presumes that any sustain/damper pedal used has a “normally
closed position” (negative polarity).
NOTE:
If an expression pedal is connected, your patch should receive a continuous
range of values. In our experience, various expression pedal models and
settings tend to deliver different ranges of values. This can be addressed at
the patch level.
• The HDMI
®
port delivers the video output of Organelle’s internal microcomputer. [For
additional information on using the HDMI port, see
chapter six
.]
• The microSD card slot contains a card that acts as the internal microcomputer’s root
disk. We do not recommend ejecting or otherwise manipulating this card as nothing
good will come of it.
• The power port (labeled
9VDC
) is for connection to Organelle’s own power supply.
NOTE:
The output specifications of this power supply are: 9VDC, 1000mA, and a tip
with center-positive polarity (
). Any power supply used with
Organelle must meet these three specifications.
Right-side Panel
Compared to the back panel, the right-side panel is
downright simple, housing two USB 2.0, Type A
Page
!
of
!
13
51