Criminalistics, Inc. 7560 NW 82
nd
St., Miami, FL 33166, (305) 885 6444, Fax (305) 885 3330
1391 Main Ave., Morton, WA 98356, (360) 496 6363, Fax (360) 496 6210
http://www.criminalisticsinc.com [email protected]
- 3 -
Switch Descriptions:
Backlighting: This switch is used to turn on and off the Temperature LCD back lighting. Up is constant On, Center is Off, and
Down is Momentary On.
Lock/On: Used to turn on the Premier Canine System and for programming the temperature alarm points.
Manual Fan Speed: This switch turns on the fan, either High (full) speed or a lower (medium) speed. This switch will NOT
override the Alarm function. In an Alarm condition the fan will run at high (full) speed until the temperature drops below the high
temperature alarm point.
Temperature Set, High/Low: Selects either the High or Low temperature alarm set point.
Up/Down: Changes the display alarm temperature set either up or down. Momentary pushing the toggle changes the set
temperature in single degree steps. Holding the toggle will scroll the temperature in the direction held. The temperature scroll
will also “wrap around” and start from the most minimum limit.
Temperature Alarm Sequence of Events: When a Temperature Alarm situation occurs 3 things happen simultaneously:
Audio/Visual indicators are activated (typically Horn Honk, Light bar, or Brake lights). Window A rolls down for 5 seconds and the
Fan comes on at high speed. After Window A rolls down Window B will roll down for 5 seconds (if connected).
Bailout (door opener) Function:
This function is activated when the button is pressed on the remote transmitter.
If the vehicle is using any of the vehicle motion sensors the door unlatch function will not function until the sensor is in an
“armed” condition. Sensor can be VSS (Vehicle Speed Sensor), Park + (a 5vdc signal when the vehicle is in Park or Neutral), or
Park – (a ground, when the vehicle is in Park or Neutral).
Sequence of events on a Door Opener button press: Door unlocks, then unlatches. The gas spring pushes the door open allowing
the K-9 partner to exit the vehicle.
Note: The Green front panel LED must be on steady for the Premier Canine System
TM
Alarm function to operate
properly.
WARNING: If jump starting the vehicle the Premier Canine System
TM
is installed in or using the vehicle to jump
start another vehicle, turn off the Premier Canine System
TM
. Failure to do so could possibly damage your Premier
Canine System
TM
and is not covered by warranty.
