Criminalistics, Inc. 7560 NW 82
nd
St., Miami, FL 33166, (305) 885 6444, Fax (305) 885 3330
1391 Main Ave., Morton, WA 98356, (360) 496 6363, Fax (360) 496 6210
http://www.criminalisticsinc.com [email protected]
- 13 -
Antenna Connector Instructions:
Step 1
Slide coupling ring onto cable. Cut end of cable even and strip jacket, braid and dielectric
to dimensions shown in table. All cuts are to be sharp and square. Do not nick braid, dielectric or center conductor. Tin exposed
center conductor and braid, avoiding excessive heat.
Step 2
Screw the plug subassembly on cable. Solder assembly to braid through solder holes
making a good bond between braid and shell. Solder conductor to contact. Do not use excessive heat.
Step 3
For final assembly on straight plugs move coupling ring forward and screw in place on plug subassembly.
Final assembly and test:
When everything is complete, connect the system to the battery terminals as mentioned previously to power up your Premier
Canine System™ Plus. Follow the directions enclosed with your antenna carefully. This antenna is cut specifically for your
Premier Canine System™. Poor range can be directly attributed to faulty antenna installation practices. Be sure the
grounding sheath is in no way connected to the signal wire, either at the plug or at the antenna (we recommend verifying this
with an ohm meter). You may now program your Maximum alerting temperature and test the unit.
Continuous pressure on the remote button is not necessary; a single firm press and release will do the job. Failure to heed
these simple instructions will cause damage to the unlatch solenoid.
NOTE:
Failure to follow the installation guide: drilling into or opening the control unit, removal of any screws,
improper mounting of the solenoid, or abusive use of the Premier Canine System™
voids the warranty
. Please do not
remove mounting brackets and/or reinsert the screws. You can pierce the circuit board causing permanent damage to your
system.
