This feature controls the length of time the starter stays engaged. If the default (0.8 seconds) is not long enough
to start the engine, change the setting to1.25 seconds.
GAS / DIESEL:
Set this switch to select the proper vehicle fuel type. Selecting Diesel delays starter activation about 10 seconds
to allow warming of glow plugs.
TACHLESS or ENGINE MONITOR:
When switch #4 is on, the system is in the Tachless mode and it is not necessary to connect the gray Engine
Monitor wire. When switch #4 is off, the unit monitors engine RPM/Pulses through the Gray wire. The wire must
be connected to a valid source when #4 is in the OFF position.
NOTE: For ease of installation, select Tachless mode first. If the vehicle will not remote start, turn Switch
#4 OFF and connect the Gray wire to a tach source.
TRANSMITTER PROGRAMMING
The supplied transmitters are programmed from the factory to operate the system. In the event you need to add
another transmitter or reprogram any transmitter to the system, follow the procedure below. ALL TRANSMITTER
CODES MUST BE LEARNED DURING PROGRAMMING.
1. Turn ignition on and off 3 times within 5 seconds leaving it on the 3
rd
time. (on/off, on/off, on) A single siren
chirp should sound if this was performed correctly.
2. Press the override/program button for approx. 3 seconds then 3 siren chirps should sound.
3. Press the #1 button on the transmitter. You should hear a single siren chirp when the code is accepted, then
and repeat this step for each remaining transmitter.
4. Turn the ignition off and wait a few seconds before trying the any of the transmitters.
TROUBLESHOOTING
10
