WIRING
J-3
2
PIN
PLUG
(WHITE)
RED-BLACK WIRE:
PIN 1:
DOME LIGHT ILLUMINATION (-) (
REQUIRES RELAY
)
Connect to terminal 85 of relay. This wire turns the dome light on for 30 seconds upon disarming of the alarm. If
the ignition is turned on or the alarm is re-armed, the dome light will turn off again.
WHITE-YELLOW:
PIN 2:
HORN HONK OUTPUT (-)
(MAY REQUIRE RELAY)
This wire provides a pulsed 150mA negative output for honking the vehicle's horn when the alarm is triggered.
Connect this wire to the horn relay in the steering column. If there is no horn relay you must install one.
NOTE: Some vehicle horns operate only with ignition on. This will require rewiring the horn circuit in order for the
alarm system to operate the horns. Call technical support for details.
J-4
2 PIN PLUG (BLUE)
J-5
2 PIN PLUG (RED)
PROGRAM/OVERRIDE
BUTTON
LED
INDICATOR
(Red flashing light)
J-6
3 PIN PLUG (RED)
GRN/BLK
PIN 1:
NEGATIVE REMOTE OUTPUT (Optional)
RED
PIN 2:
FACTORY DISARM
(Negative pulse)
YELLOW
PIN 3:
VACUUM INPUT (Used when installing a vacuum switch for engine monitor)
J-7
3 PIN PLUG (WHITE)
GREEN
PIN 1:
NEGATIVE LOCK
Connect directly to negative lock/unlock systems. If vehicle uses
RED
PIN 2:
+12V For Relays
positive door lock signals or reversing polarity type, then external
BLUE
PIN 3:
NEGATIVE UNLOCK relays must be added. Door lock wires are usually found in
J-8
4 PIN SENSOR PLUG (22 GAUGE WIRES)
WHITE
PIN 1:
NEG. PRE-WARN
The Dual Stage Pre-Warn Shock sensor connects directly to
BLACK
PIN 2:
SENSOR GROUND Alarm Brain with 4-Pin harness.
Note: If adding additional
BLUE
PIN 3:
NEG. TRIGGER
sensors, you must diode-isolate the extra sensor’s trigger
RED
PIN 4:
12V
wire.
Place a diode in-line with band (cathode) towards the
sensor.
OPERATION
5
