A1018B – OUTDOOR RECEIVER KIT (REMOTE SWITCH UHF 12/24Vd.c.)
Features
:
1.
2 Channels (A & B) independently set-up.
2.
Buttons have slide protector to prevent accidental
activation.
3.
Can learn over 100 transmitter codes
4.
Hopping (Rolling) Code technology – Provides a
secure encrypted radio frequency (RF) transmission.
Learning Mode: Programming:
NOTE: The radio control units included in the pack are
already programmed and ready to use.
See the above diagram to find the correct buttons to
press.
Press the P1 as instructed below to enter different
modes:
ONE time to program R1 in monostable mode - LED
flashes one time and stays alight, then press the button
that you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The
control mode of relay is non-locking (state A).
TWO times to program R2 in monostable mode - LED
flashes two times and stays alight, then press the button
that you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The
control mode of relay is non-locking (state B).
THREE times to program R1 in bistable mode - LED flash
three times and stays alight, then press the button that
you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The
control mode of relay is interlocking (state C).
FOUR times to program R2 in bistable mode - LED flash
four times and stays alight, then press the button that
you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The
control mode of relay is interlocking (state D).
Note
: If you press P1 many times, the state D will
deactivate. Hold down the key of the radio remote
control that you would like to acquire until the led
blinks.
Deleting Programmed Codes:
There are two ways of deleting saved codes:
1.
Deleting a single code -Press P2 button for about
two seconds and release. The LED will light up.
