17
OPERATING INSTRUCTIONS
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has not yet
been opened. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without you knowing it.
This feature can also be turned off in programming option (6). Active rearm feature is disabled if you also have dome light
illumination installed.
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the Second auxiliary output press the Bank#2 Button on the side of the remote first, then Press Button #4 (Panic) to
activate AUX. channel #2.
ARM/DISARM WITH IGNITION ON (PROGRAM OPTION #15)
This feature allows the system to be armed or disarmed while the ignition is in the ON position or vehicle is running. The feature
is disabled by default and should not be used under normal operating conditions. On an installation with an add-on remote start
module, this option can be enabled to allow the system to be armed or disarmed when the vehicle has been remote started
(Ignition will be ON). Note that you cannot use this feature if you are also using the Full-time carjack protection. If you add a
remote start and the Ignition turns on, a Carjack trigger will be activated.
CARJACK PROTECTION FEATURES
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming option (14) See
page 10. When the Ignition is on (vehicle is running), press button #4 (Panic). Parking lights will flash TWICE to confirm the
Carjack countdown sequence. LED begins to flash slowly. 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20
seconds of pre-warning chirps turning into a full system activation with siren/flashing light pulses for 5 min. To reset Active
Carjack, IGNITION MUST BE ON, then press Button #2. Siren/Horn chirp, LED goes OFF, carjack is reset.
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming options (13) &
(14). See page 10. We recommend this mode should only be used in serious situations. When the Ignition is on (vehicle is
running), and a door is opened and closed, the Carjack countdown sequence will be initiated (lights flash twice & LED begins to
flash). 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a full
system activation with siren/flashing light pulses for 5 min. To reset Passive Carjack, Ignition must be ON, doors must be
closed, then press the override/program button (3) times. Siren chirps once, LED goes out, carjack is reset. NOTE: Active
carjack can still be used when the Passive Type carjack is activated.
