40
• = Default Factory Setting
1) Transmitter Learning Mode
Programming A Remote Control To Operate the Primary Vehicle:
Press & Release the Large button on each remote control to be pro-
grammed. All of the remotes channels will be learned.
Programming A Remote Control To Operate A 2nd Or 3rd Vehicle:
Up to three systems may be independently operated using a single remote
control. The remotes button functions are different for each vehicle. This
prevents Arming & Disarming the multiple systems simultaneously.
(Refer to the following chart for button function assignment)
Arm/Disarm
Aux Channel #1 Aux Channel #2
Large Button
Small Button Small Button
Small Button
Large Button Small Button
Small Button
Large Button Small Button
To program: Press & Release either of the small buttons on each remote
control to be programmed. The system will automatically learn all of the
remotes channels in a different order.
Important:
When a new remote control is programmed into the system, all
previous remotes in memory will be automatically deleted. If a third or fourth
remote control is desired, all of the remotes must be programmed into system's
memory.
2) Programmable Override Valet Code:
( 1 Press)
To enter a new valet override code: (1-12 Presses: 12 Maximum)
a) Press & Release the Large button on the remote control.
-
The siren will chirp once to confirm system is ready to accept new code.
b) Press & Release the Easy Valet switch 1-12 times before 5 seconds
elapse. This number will be the new override code.
-The siren will chirp 1-12 times to confirm the number entered.
Note: If no additional features need to be programmed, exit programming
mode by allowing the 10 second time limit to expire without input.
Do Not exit programming mode by turning On the ignition.
