2. Use the two included 6-32 x 1/2 in. screws to attach the front portion
of the TSW-UMB-70 to the TSW-UMB-70-BBI.
3. Remove the appropriate knockout(s) on the TSW-UMB-70-BBI for
routing wiring to the touch screen.
4. Route wiring through the knockout(s) and out through the front
opening in the TSW-UMB-70.
5. Use the dimensions shown in the illustration above or listed on the
to create an appropriately sized cutout in the mounting
surface. No minimum clearances are required.
6. Mount the TSW-UMB-70-BBI into the cutout in the mounting surface
as shown in the following illustration. Ensure the "TOP" text on both
the TSW-UMB-70 and TSW-UMB-70-BBI is facing upward prior to
installation.
The TSW-UMB-70-BBI can also be mounted vertically for use with the
TSW-570P portrait touch screen.
l
Rotate the product 90º to the right to determine the necessary cutout
dimensions for portrait mounting. Refer to the image below step 2 for
dimensions.
l
Ensure that the the "TOP" text on both the TSW-UMB-70 and
TSW-UMB-70-BBI is facing to the right, and then install the
TSW-UMB-70-BBI into the cutout.
2
TSW-UMB-70-BBI
Quick Start
Wall Mount Back Box for TSW-70 Series
