Crestron QM-FTCC-TPS4, Руководство по эксплуатации и установке

Страница: 17 / 52

Crestron QM-FTCC-TPS4 FlipTop Touchpanel Computer Center
of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.
Insert the tinned connection into the Cresnet connector and tighten the retaining
screw. Repeat the procedure for the other three conductors.
NOTE:
For larger networks (i.e., greater than 28 network devices), it may become
necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality
throughout the network. Also, for networks with lengthy cable runs, it may be
necessary to add a Hub/Repeater after only 20 devices.
QM Network Wiring
When connecting multiple QM devices, the route between a QM origination point
(e.g., QM-FTCC-TPS4) and a QM endpoint (e.g., QM-RMCRX-BA) cannot have
more than two midpoints (e.g., QM-MD7x2 or other QM switchers). Refer to the
following diagram when configuring a QM network. Refer to Appendix B on page
43 for additional QuickMedia information.
QM Network Topology
QM-FTCC-TPS4
QM
QM QM
QM
QM
Origination Points Endpoints
QM
Midpoints
QM-FTCC-TPS4
QM-RMCRX-BA
QM-RMCRX-BA
QM-MD7x2 QM-MD7x2
QM-FTCC-TPS4
Crestron Toolbox
The Crestron Toolbox (replacement for Crestron Viewport, you may continue to use
Viewport if desired) is a broad-based software package that accomplishes multiple
system tasks, primarily using an RS-232 or TCP/IP connection between a PC and
one or more Crestron control systems.
You can use the Crestron Toolbox to:
•
Observe system processes.
•
Upload operating systems and firmware.
•
Upload programs and touchpanel projects.
•
Set or change device Network IDs.
•
Change serial numbers.
•
Run scripts to automate tasks.
•
Perform system diagnostics, and much more.
The Crestron Toolbox allows you to perform these functions using simple graphical
views and click and drag methods.
Identity Code
Every piece of equipment and user interface within the network requires a unique
identity code (Net ID). These codes are two-digit hexadecimal numbers from 03 to
Operations & Installation Guide – DOC. 6393 FlipTop Touchpanel Computer Center: QM-FTCC-TPS4
•
13