Crestron QM-FTCC-TPS4, Руководство по эксплуатации и установке

Страница: 15 / 52

Crestron QM-FTCC-TPS4 FlipTop Touchpanel Computer Center
NET (x2)
24 Y Z G 24 Y Z G
NET
These two 4-pin terminal block connectors are for connection to the Cresnet
network. One connector is used to connect to the Cresnet network while the
second connector can be used to connect another Cresnet device. Cresnet
power to the QM-FTCC-TPS4 is supplied through either of these connectors.
For more information, refer to “Network Wiring” on page 12.
AC Power
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to the
outlet on the topside of the QM-FTCC-TPS4.
125V – 50/60Hz 10A
The international version (QMI-FTCC-TPS4) is equipped with a standard
IEC-320 electrical appliance coupler. The IEC (International Electrotechnical
Commission) is the international standards and conformity assessment body for
all fields of electrotechnology.
MAX 250V~50/60Hz 10A
LAN
8
1
Yellow
LED
Green
LED
An 8-wire RJ-45 connector with two LED indicators (green LED indicates link
status, yellow LED indicates Ethernet activity). This connector provides an
Ethernet 10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, DHCP, IEEE
802.3U compliant network connection for the TPS4 touchpanel.
LAN Connector Pinout
PIN SIGNALS PIN SIGNALS
1 TX + 5 N/C
2
TX -
6 RC -
3 RC+ 7 N/C
4 N/C 8 N/C
Indicators (Underside)
PWR (Power)
This LED illuminates when 24 volts DC is supplied to the QuickMedia module
from Cresnet.
NET
This LED illuminates when communication between the control system and the
QuickMedia module is established (the QM unit is polled on the network).
Illumination indicates that the SIMPL Windows program currently loaded has a
network device defined at the same Net ID as the QM-FTCC-TPS4.
SETUP LED and Pushbutton (Underside)
The QuickMedia module is Touch-Settable ID-ready. A
SETUP
pushbutton is
located on the bottom side of the QM-FTCC-TPS4. The
SETUP
pushbutton and
its associated LED are used for setting the QuickMedia module’s network ID
during the initial configuration of a Cresnet system or when the device is being
added/replaced.
Operations & Installation Guide – DOC. 6393 FlipTop Touchpanel Computer Center: QM-FTCC-TPS4
•
11