2-Series Professional Media Controller
Crestron
MC2E
System Monitor
The System Monitor allows firmware to be reloaded into the MC2E in the event that
firmware cannot be loaded in the normal mode.
Perform the following procedure to correct the “System does not function” trouble
situation on page 35 (in reference to Corrective Action).
If the system does not function, perform the following procedure:
1. Connect DB9 straight-through RS-232 cable between the PC and MC2E.
Refer to “Hardware Hookup” on page 14.
2. Open Viewport and select
Setup | Communication
Settings
to open the
“Port settings” window.
3. In the window, select
RS-232
(Connection Type),
57600
(Baud Rate),
N
(Parity),
8
(Data Bits),
1
(Stop Bits),
RTS/CTS
On,
XON/XOFF
Off, and
click
OK
.
4. Power down the MC2E.
5. While powering up the MC2E, press and hold
ALT
+
K
on the keyboard
until the following text (or similar) appears in Viewport.
System Monitor [v1.001 (0001)]
12-19-01 16:25:23 32MB RAM, 4MB FLASH
CS>
NOTE:
After this, the baud rate can be increased to 115200 (for faster
communication) by pressing F8 on the keyboard and then selecting 115200 from the
“Set Baud Rate” window.
6. At the Viewport prompt, type
erase
and press
Enter
. The following text
appears in Viewport.
CS>erase
->25%->50%->75%->100%
Done
CS>
7. At the Viewport prompt type:
System
and press
Enter
. When the letter
C
appears in Viewport, proceed to the next step.
8. Press
ALT
and
O
(not zero) on the keyboard. The “Open” window
appears.
9. Find and select the correct firmware file (.CUZ) and click
Open
.
10. Once “Completed Successfully” appears in Viewport, type
quit
at the
Viewport prompt and press
Enter
.
36
•
2-Series Professional Media Controller: MC2E
Operations Guide - DOC. 6142
Содержание MC2E
Страница 1: ...Crestron MC2E 2 Series Professional Media Controller Operations Guide ...
Страница 4: ......
