52 • HD-PS401 and HD-PS402
Web Interface Configuration Guide — Doc. 9196B
e. Command Terminator: Select the value from the drop-down list to append to the
terminator.
l
None (default)
l
CR
l
LF
l
CR LF
f. Output Timeout: Set Output Timeout to enable the display device to turn off after a
predetermined period of time in which no signal is detected. Select the desired
number of seconds, or select Custom and then set the desired timeout in seconds.
g. Command (Power Off): Triggers the power off command as per the selection.
h. Command (Power On): Triggers the power on command as per the selection.
i. InputControl: Enable (slide to right). Set the Delay from the drop-down list and type
the command in the Command String field to trigger the operation.
Routing
The Routing section can be used to establish routing between inputs and outputs. Here you can
see the status of the current routing.
Set the Auto Route slider to enabled (right) or disabled (left). Auto route order is based on the
order the sources are connected or disconnected. It does not take manual routes triggered by the
